Paranormal MIDI activity

[Dovius]

Hi,

I have build megadrum by syntex's PCB, programmed MCUs. The trouble is that I dont get proper Midi activity. LCD shows everything just fine, but MIDI-OX show only this



only very few strikes are recognized, my LED on pcb also doesnt glow. I striked for about 50 times and get only this



Is it possible, that I programed fuses wrong?
only thing I did was programming PIC like this



and Atmega644 only this



I didnt anything else. I read about low, high bits, but dont know anything about it.
Did I programed MCU allright?
What problems could be??

P.S.
I have alreadt burned atmega644 once )

[dmitri]

Most likely reasons:
1. Incorrect crystal for Atmega.
2. Mismatch between PIC firmware and PIC crystal.
3. Incorrect fuses programmed into Atmega.

[Dovius]

So for programming fuses for atmega644 I just only need to do this ?

[dmitri]

If you programmed it with a unencrypted bootloader (which is useless) then fuses look correct.

[Dovius]

finally... MegaDrum is working.... fuf.. lots of work for noobie as me my fault was that in ponyProg I clicked write a Device, istead of write EEPROM still some little bugs, but everything is fine Thank You Dmitri wounderful project