dmitri wrote:Did you ever open the module and disconnect the buttons cable? If yes, then you probably re-connected it incorrectly.
Well...I didn't recall disconnecting the cable but...
I just disconnected it and spun the cable around to reverse the pin order, and what do you know!
Thanks for all your help! I feel a little sheepish now.
I did have another issue that I need to check up on. The last time I was using the MD I had an issue where all the channels suddenly jammed on at once at full velocity. Causing a cacophony! Hopefully that has resolved with the firmware update:) If not you may see me back on the forums!
Thanks again for your time:)
Michael