New firmware version and improved Noise Filterning.

[dmitri]

There must be something else involved. I just tried to toggle AltSampling several times both from MDMFX and from the module itself and I just could not reproduce the problem.
Can you start MegaDrum with default settings and see if the problem still there?

[sbonasuk]

Ignotus Hi would you mind posting your typical misc and rim/edge settings from the snare, I cannot seem to lower the threshold without causing double triggers

regards

[ignotus]

Ignotus Hi would you mind posting your typical misc and rim/edge settings from the snare, I cannot seem to lower the threshold without causing double triggers

Here's a screenshot of my snare settings. It's all in blue because I'm on another PC not connected to MD. However, being a DIY pad, I doubt my settings will be of any use to you.

MDMFX_screenshot.png

Can you start MegaDrum with default settings and see if the problem still there?

If I start MD with default settings the problem goes away. I'll attach my config file so you can see if you can spot anything there.

[dmitri]

Please test this version:

20181031.zip

[ignotus]

That fixed it. Cheers!

[dmitri]

Thank you for testing! I've updated the latest firmware version to include the fix.

[Rovalo]

Hello Dmitri,

I started from scratch setting up MD with the 20181218 firmware using noise filtering at max level 9 and AltSamplingAlg active.

I was hoping the noise filtering would solve an old issue False kick triggers when releasing HH pedal.
Result: together with HH high level reduction to 130 (by a 100kE resistor on V+), the noise reduction completely solves the open HH crosstalk to kick input 1 issue . Thanks!

The only warning you mentioned about a too high noise filtering setpoint is related to positional sensing, I will not need that. But before I continue setting up more pads, can you confirm that continuing with noise level reduction at max level 9 is OK and should only give better results than lower levels and has no other disadvantages?

[dmitri]

No disadvantages I can think of. You may need to adjust Threshold levels on switch inputs compared to old algorithm without noise filtering.

[Rovalo]

Thanks, then I continue with these settings and will adjust all threshold levels.