History of MegaDrum firmware versions

[japi]

Have you tried loading the default settings holding the right button on startup ?

[Synthex]

Here it is !

But try loading the default settings holding the right button on startup.

[dizzib3]

Thanks for the link. AFAICT there does seem to a difference in AutoLoad Conf behaviour between 20081218 and 20090211...

20090211: megadrum32_20_32_20090211.syx

Set AutoLoad Conf -> Yes
Save Config -> 1 -> Right click -> Done
View AutoLoad Conf = Yes
Load Config -> 1 -> Right click -> Done
View AutoLoad Conf = No


20081218: megadrum32_20_32_20081218.syx

Set AutoLoad Conf -> Yes
Save Config -> 1 -> Right click -> Done
View AutoLoad Conf = Yes
Load Config -> 1 -> Right click -> Done
View AutoLoad Conf = Yes


Also, I did try pressing the right button on booting but it didn't seem to make any difference. TBH I'm not sure if I'm doing something wrong.

[dmitri]

dizzib3, I fixed this issue in the 20090301 firmware version.

[dizzib3]

Much appreciated dmitri, I can confirm 20090306 seems to have fixed it!

[elrules]

3. Inputs with a note set to 0 are now considered as disabled.

Regarding this modification, does this affect only to trigger inputs or is it the same for hihtat pedal notes?

I want to implement a textfield in MCT that changes its text to "Disabled" when you move the slider to the minimum, and i would like to know if i must apply it only to trigger inputs.

[dmitri]

It only applies to trigger inputs.

[kimouette]

Problem with Latest MegaDrum firmware : megadrum32_20090508

I have just installed the latest firmware on my MD and now I have a problem!
When I try to load config 1 I automatically get the following screen:

screen1.JPG

As you can see the Vu-meter is kind of messed up!
If I try to use any of the 4 buttons, I get the following screen :

screen-drummap.JPG

And from that screen I can only chose between Loaded drumMap's numbers.

If I unplug my MD and try to load Config 2 instead of 1, I get the following screen :

config 2.JPG

And I'm just stuck there. The buttons dont even respond after Config 2 has been loaded.

I wanted to make sure the problem was related to the new firmware update, so I went back to the previous version (20090427), and the MD goes back to normal. I tried to reinstall the "20090508" firmware again, and the same problem occures.

Oh and maybe I should mention that I'm using the "megadrum32_16_32.sys" version like I always did

[dmitri]

I cannot reproduce the problem. Anyone else with the problem?
Try reloading the firmware.

[kimouette]

I cannot reproduce the problem. Anyone else with the problem?
Try reloading the firmware.

Same thing