www.megadrum.info

Hi there,
I'm frarobertooo from the spaghetti country of Italy :
I'm quite new to electronics and I do not understand something on MegaDrum Schematics page. I have found the MegaDrum Analogue Board - 32 inputs version image where I read that I'll need a couple of Analogue Board but in the Megadrum Atmega32 Digital Board I could find input connectors only for a single Analogue Board (analogueconnector 1 and 2).
What am I missing????
Thank you for the hard work!!!!
frarobertooo

You connect both Analogue boards to the same connector on the Digital board using the same cable. Just as you do when you connect two hard drives to the same connector on a motherboard using one cable. Then you shorten jumpers J2 and J3 on the first Analogue board and jumpers J4 and J5 on the second Analogue board.

There is also the "All in One" PCB.

dmitri wrote:You connect both Analogue boards to the same connector on the Digital board using the same cable. Just as you do when you connect two hard drives to the same connector on a motherboard using one cable. Then you shorten jumpers J2 and J3 on the first Analogue board and jumpers J4 and J5 on the second Analogue board.

Ah!
Thank you very much. I was totally lost

Synthex wrote:There is also the "All in One" PCB.

Thank you Synthex.
I knew it, but first I needed clarification on the other projects
Bye bye and thanks for the info!!!

frarobertooo wrote:Bye bye and thanks for the info!!!

You're welcome !