www.megadrum.info

Hi!
So I have 2 pcy135 and am trying to get them to have 3 zones. I am starting with the ride.


I have done the configuration process advised on megadrum configuration.
Right now I have bow sound and bell sound but no edge. What can I do? But the weirdest thing happens. My choke is working on the bell!
How weird is that?

Raise Threshold by 1 on the Edge until pressing/releasing the edge switches STARTS to generate Aftertouch messages (choking). Note the Threshold level you set as level1.
Continue to raise Threshold on the Edge by 1 until pressing/releasing the edge switches STOPS to generate Aftertouch messages (choking). Note the Threshold level you set as level2.
Set the Threshold on the Edge to (leve1+level2)/2.
Also see http://www.megadrum.info/content/settin ... one-cymbal

Its working, thanks so much,
Any advice on improving the separation between bow and edge hits? Since I cannot use threshold what other settings should I use?
Thanks

What is the problem with zones separation between the bow and the edge?

When I hit the edge lightly it only triggers bow. I can only get edge sounds when I hit the edge hard and it also triggers the bow.

chain wrote:When I hit the edge lightly it only triggers bow.

If you hit the edge slightly it doesn't make - it is a switch so you have to hit it with some force to trigger it.

I can only get edge sounds when I hit the edge hard and it also triggers the bow.

You need to raise DynLevel and DynTime on both Bow and Edge and possibly Threshold on the Bow.