little jumping values on CC4 Hi Hat Pedal
Posted: Mon Oct 16, 2017 1:54 amHi fine people from this forum. I'm posting this new topic because i got a little issue with my Hall Sensor Hi Hat Pedal, Using UGN503 Hall Sensor.
I could put all the settings on megadrum to have the full range of the pedal, wich works fine, but the only problem that i got is that, in all the in between levels, the signal is not 100% stable, it keeps jumping around 1 or 2 points up or down of the 127 midi points.
In the full open or full closed, the signal is stable, in all in between, it jumps a little, and is problematic when using Superior Drummer or EZ Drummer, because it causes some kind of bit crusher effect in some levels of openess.
I'm using last unencrypted firmware wich do not have the option of cc filtering.
I tested with another UGN503 and another magnet and the problem is the same. I don't think that using another hall sensor would finish the problem.
I saw some other post with similar issues like this. Any ideas my friends?
I could put all the settings on megadrum to have the full range of the pedal, wich works fine, but the only problem that i got is that, in all the in between levels, the signal is not 100% stable, it keeps jumping around 1 or 2 points up or down of the 127 midi points.
In the full open or full closed, the signal is stable, in all in between, it jumps a little, and is problematic when using Superior Drummer or EZ Drummer, because it causes some kind of bit crusher effect in some levels of openess.
I'm using last unencrypted firmware wich do not have the option of cc filtering.
I tested with another UGN503 and another magnet and the problem is the same. I don't think that using another hall sensor would finish the problem.
I saw some other post with similar issues like this. Any ideas my friends?
maybe i need another program that you know about and i don't