so how does this work?

[ddropski]

Hello everyone I'm trying to set up my Roland ride cymbal cy-15r and I have a few questions

1) so my cymbal has 3 possible sounds edge, Bow, and the bell but between aux 1 and 2 there are 6 possible sounds AUX 1 = Head, Rim, Zone 3 and Aux2 has Head, Rim, Zone 3 that would be 6

I think zone 3 only refers to cymbal muting then which one is used? (aux 1 or 2).. and that still leaves 4 Zones and 3 sounds . and before you tell me to read the manual or the "setting up a 3 zone cymbal post" I did it says aux 1 head is bow and bell and aux rim is the edge (what do i do with the extra unused sections) the aux1 head and the extra 3rd zone ? which ever one is not used? do I dissable them? .. make them the same note as another section ?

also on the used zone 3 what value do i set dampend note to?


2) in the instruction manual you mention terms like PBNote, ANote, BNote etc... what does that mean?
i googled it but it turned up nothing .


thanks

[dmitri]

For setting up 3way Roland cymbal please see viewtopic.php?p=17613#p17613
For PBNote, ANote, BNote please see https://www.megadrum.info/content/pads-settings