www.megadrum.info

Hi guys.

Does anybody know if it's possible to connect two piezos to a one input in MD?
Say for example I went from single kick to double kick pedal and have separate piezo In each beater.
Now. Do I connect it through a Y wire = two piezos into a stereo jack and onto kick input inMD ?
Or is the MD all mono ins and instead of Y wire I should run two mono wires and just assign it to a different input on MD ? And is it same for say two or three zone snares and Toms and Cymbals ?

How do we go around it guys ?
Are the inputs mono or stereo?

Thanks !!

The pre made unit you have are stereo sockets.

Thank you Mark.
I've checked your YT .
You're a fucking monster mate.
Love the kit and love the vibe .
People like you shall have a spacial place on this forum .
Knowledge, experience, sharing,ideas and creativity .

Thank you Sir

I'd skip the kick input because it's only a single piezo input. All the rest are stereo, which accept either:

- Piezo + piezo as separate mono pads (what you'd do here with your 2 separate kicks).
- Piezo + piezo dual pads (two piezos on the same pad)
- Piezo + switch (e.g. dual zone/dual zone + choke cymbals).
- Piezo + switch + switch (3-zone pads).

There are more than enough inputs to be able to leave the kick input unused.