Page 1 of 1
Inline pad cooler (cure for hot cymbal)
Posted:
Sat Oct 31, 2009 12:52 pmby jman 31
I am making an inline box to cool down the piezos on my 3-zone cymbal. What would be the proper way to wire it up. I was planning on using two stereo jacks and one or two 100K pots depending on what I needed. Is there a wiring diagram here for hot pad pots?
Re: Inline pad cooler (cure for hot cymbal)
Posted:
Sat Oct 31, 2009 1:00 pmby jman 31
Would this be it?
Re: Inline pad cooler (cure for hot cymbal)
Posted:
Sat Oct 31, 2009 3:25 pmby rockdude
I've reduced some of my pads with this wiring:
Re: Inline pad cooler (cure for hot cymbal)
Posted:
Sat Oct 31, 2009 3:52 pmby jman 31
Thanks Rockdude. I need to know how that would relate to a stereo jack though. I could probably put a pot on both lines, but I don't know if that is the proper way or not for this situation.
Re: Inline pad cooler (cure for hot cymbal)
Posted:
Sat Oct 31, 2009 8:40 pmby dmitri
Re: Inline pad cooler (cure for hot cymbal)
Posted:
Sat Oct 31, 2009 9:19 pmby jman 31
dmitri wrote:http://www.megadrum.info/forums/viewtopic.php?p=11911#p11911
Cool! Thanks Dmitri, I thought I had seen that somewhere before.
Re: Inline pad cooler (cure for hot cymbal)
Posted:
Sun Nov 01, 2009 12:08 pmby rockdude
I've never built a voltage divider before. Maybe it's even better than a pot. Please post a picture of yours if you decide to build one Jman.