Fem questions.

[dmitri]

1. Why did you set head Type to '3way roland'? Is it a piezo/piezo or a piezo/switch/switch (3way roland type) pad? If it's a 3way Roland type piezo/switch/switch pad/cymbal you have to configure it like this: viewtopic.php?p=17613#p17613
2. Why HighLevel on the rim is still 64? Is it connected properly? Is it a piezo on the rim or a switch?
3. If you set head Type to 'Single', head and rim 'HighLevel Auto' to Yes (check) and hit hard several times head and rim what do you get in HighLevel on both head and rim? Post a screenshot showing this.

[LouisCarter]

1. Why did you set head Type to '3way roland'? Is it a piezo/piezo or a piezo/switch/switch (3way roland type) pad? If it's a 3way Roland type piezo/switch/switch pad/cymbal you have to configure it like this: viewtopic.php?p=17613#p17613
2. Why HighLevel on the rim is still 64? Is it connected properly? Is it a piezo on the rim or a switch?
3. If you set head Type to 'Single', head and rim 'HighLevel Auto' to Yes (check) and hit hard several times head and rim what do you get in HighLevel on both head and rim? Post a screenshot showing this.

1. Sorry, im kinda rolling around the dirt here, trying so many settings. I have like i said in the second post a "roland type 2 piezo's" setup.
2. I just tried taking of the mesh head, Punching both piezo's gives me Channel 38 signal only still. Same signal strength on both piezos. This is the reason why highlevel is still 64.
3. If i set head type to "single" both head and rim highlevel auto, i only get signal from channel 38. SnareR Highlevel is not reacting at all.

[LouisCarter]

OK -

Wow.

SnareH and SnareR is shorted. (37-38)

When i take my multimeter and measure these to they clearly have a connection to each other.

Makes me wanna scream at the top of my lungs. haha.

What now?

[dmitri]

After you removed the short, did you correct settings? Do you get signal on the rim now? Is there still a problem?