pic programming failed

[jman 31]

Oliboy, where are you located. PM me if you don't want to say on the board.

Jman

[oliboy]

just asked for helped from a friend and i just programmed my pic using pickit2...what a relief that it's not faulty...it's the board that has the problem...about to build a new one...just a few question...i just browsed the new components list and found this changes...just want to know which is the correct values...thanks...
old new
R2= 4K7 - 1K2
R7= 10K - 2K7
R8= 6K2 - 2K2

[dmitri]

just want to know which is the correct values...thanks...
old new
R2= 4K7 - 1K2
R7= 10K - 2K7
R8= 6K2 - 2K2

Either all old or all new will work fine.

[oliboy]

thanks...will i be needing resistors 26-29?..

[dmitri]

thanks...will i be needing resistors 26-29?..

Yes.

[oliboy]

i've already program my pic using the old 12Mhz hex file...if i change or add something to the board...will i have to reprogram it?..

[Firelord]

i've already program my pic using the old 12Mhz hex file...if i change or add something to the board...will i have to reprogram it?..

If your changes do not affect MegaDrum's current design specification, then no.

[oliboy]

i'm going to add resistors 26-29...

[Firelord]

i'm going to add resistors 26-29...

What do you mean by 'add'? They are already part of the design.

[oliboy]

the first one i got and already built did not have resistors 26-29...
i'm about to rebuild my board so i'm wondering if this addition would affect the program i placed in the pic...i used a different programmer because i can't program it with the programmer in the board....