>>> KIT AVAILABLE <<< All In One v3.2 PCB 56i Kit for sale !

[Akkue39]

A question more about this. Is this AUX a dead one? Because if i connect a pad with this input (above the kick input), i don't get any signal. Is this correct?

The AUX is not connected to the Megadrum, it's only a jack.

Thank you synthex. I thought i have an solder problem. Now i can sleep well

[audiophonicz]

@Synthex

Brilliant! I thought I read somewhere that the controllers were already programmed, and I figured on the USB header but I wasn't 100%. So basically I dont NEED any of the pin headers except the keyboard. Thanks for the quick answer, once again I'm glad I bought the kit!

[minicoco]

Hi everyone.

I'm trying to make a manual with a step by step guide with pictures, but I'm so bad with schematics and I have many doubts with my kit, so I ask for your help.

I have soldered it, but now I don´t know if it's correct and what to do with several cables.


Correct?


Rigth?


Ok?


Great?


This way?



What I have to do with that?Where I have to conect it?



It's necesary to use every conector?


And, what about the jumpers? Where have I to put them?

Thaks a lot for your help.

More pictures here.
http://img265.imageshack.us/gal.php?g=29032010236.jpg
http://img51.imageshack.us/gal.php?g=30032010248.jpg

[Synthex]

Correct?
Right?
Ok?
Great?
This way?

Everything seems ok !

What I have to do with that?
Where I have to connect it?

This is the USB connector on 32 inputs board.
You have to connect it to the main board to use it.

It's necesary to use every connector?

No.
All ICSP connector should not be used and Rotary connector is an option.

And, what about the jumpers?
Where have I to put them?

Please read at the end of this post :
http://www.megadrum.info/forums/viewtopic.php?f=3&t=1139&start=0#p13653

[minicoco]

I tryed to conect it right now without inputs boards.

It works but:

The led is off, and I tried to change the polarity with the same result.
The display is iluminated but nothing else
My pc does not recognice it.

Any suggestion?

[Synthex]

Crystal 20MHz must be used for the Atmega644
Crystal 12MHz must be used for the 18F14K50

[minicoco]

Thakyou very much.

I'm going to do it and them prepair a guide with pictures.

Thanks!


I'd chaged the wrong elements, but I have the same problem.

The led is off
The display has light but no vumeters
My pc does not recognice it.

[theloner]

Hi Synthex
If i order, how long i have this kit, i lives in Vietnam

[Synthex]

Hi Synthex
If i order, how long i have this kit, i lives in Vietnam

The delivery time is about one week for europe and less than two weeks for the rest of the world.

[mpessanha]

Hi Synthex,
I´m from Brazil and i´m supposed to buy this complete kit(with boards/components/inputs). Well, i want to know if you already have a kit to sell and how long it takes to be sent?

Thanks for all,