ATMEGA NOT Detected!!

[silnangmarak]

When i tried to flash ATMEGA32 using ISP, ponyprog and winpic did not detect the device!! why is that!! need help ASAP!!

[dmitri]

Wrong ISP wiring.
No power fed to Atmega.
Wrong Ponyprog/Winpic configuration.
Bad PCB soldering - Atmega soldered incorrectly, breaks/shorts.
Broken Atmega.
Broken LPT port.

[silnangmarak]

Wrong ISP wiring.
No power fed to Atmega.
Wrong Ponyprog/Winpic configuration.
Bad PCB soldering - Atmega soldered incorrectly, breaks/shorts.
Broken Atmega.
Broken LPT port.

OK!!

ISP wiring is OK!
How will I fed the power to ATMEGA?

[dmitri]

Provide power to the board where Atmega is soldered in.

[silnangmarak]

Atmega is on the Board!! How will I fed the power and from where??? USB or Parallel port?

[dmitri]

From USB

[silnangmarak]

Thanks!! But still not detected!! Any solution?

[silnangmarak]

Also I tried to Flash the PIC using WinPic800 but i got the following error!

ERROR -> Writing address 0x000000
written 0xEF30 Read: 0xFFFF

What wrong?

[Firelord]

Also I tried to Flash the PIC using WinPic800 but i got the following error!

ERROR -> Writing address 0x000000
written 0xEF30 Read: 0xFFFF

What wrong?

The programmer sent an instruction to write a word 0xEF30 to address 0x000000 but during verification the word returned was 0xFFFF (empty).

[silnangmarak]

SO how will I program the PIC without ERROR?