PCB DESIGN - All In One v2.5 - 32 inputs with 74HC4851

[Lukashenka741]

thanks dmitri! but damn I was sure it will work.. oh well, now I must buy it from you

[dmitri]

I have a feeling that even pre-programmed Atmega might not help you.

[Lukashenka741]

can I do like here ? http://www.megadrum.info/forums/viewtopic.php?f=3&t=111

[dmitri]

You can.

[jinwon]

I have the pcb now, I'm now putting components that I already have to it. Synthex, could you make a part list for this pcb?

You can see the list of components on the top of the PCB. It's the "same" as v2.4.

I've attached a list of V2.5 components and confirmed it with Synthex. It does only differ slightly from the V2.4 list.

I'm going to try my best to produce a complete list of all components, including cables, cable ends, case, etc. sourced from Mouser.com to hopefully facilitate easy drag-and-drop ordering of a complete 100% DIY Synthex V2.5 "kit" from within the US. However, due purely to the massive amount of products offered at Mouser.com it'll take some amount of effort to figure out which capacitors/resistors/etc. are appropriate.

Hi, I have a question... I compared the list of components file that you uploaded and v2.5 all in one picture... but there are one different thing... there is 47uF Capacitor in the picture... but there is 4.7uF Capacitor(25v radial electrolytic or tantalum) in your file(list of v2.5 components) Which one is correct?? and if 47uF is correct, then Do i have to use 25v radial electrolytic or tantalum type Capacitor??