KIT AVAILABLE !!! All In One PCB Kit to sell !!!

[slayer666]

4. with IDE cable there will be no electromagnetic shielding between channels

Yes, but for 10 or 20 cm, it is not a drama.

True, I have no problems whatsoever. My ribboncable is about 20cm long.

[elrules]

Hi Synthex, when are your kits going to be available?

Another question. In part list it says you have to use a 1mH inductor. Can I use a 1.2mH inductor? In my local store they don't have 1mH

[Synthex]

Hi Synthex, when are your kits going to be available?

Another question. In part list it says you have to use a 1mH inductor. Can I use a 1.2mH inductor? In my local store they don't have 1mH

Hello elrules,

Yes, you can use a 1.2mH inductor.

[spugnoid]

Hey Synthex, just wondering if the 2.7 board was back from the printer yet?

Rod.

[hozone]

hello Synthex,
i'm wondering if the 2.7 back panel will be available for download.

regards,
hOZONE

[Synthex]

Hey Synthex, just wondering if the 2.7 board was back from the printer yet?

Rod.

PCB 2.7 boards are still in transit. I have to receive them in the next days ...

[Synthex]

Good news !!
Kit Version 2.7 is now available !!

Go to : http://www.megadrum.info/forums/viewtopic.php?f=3&t=187

[robotfriend]

I want to make the single-layer all-in-one PCB by etching it at home. Is the latest single layer pcb v2.3? Where is the inventory list for it? Does it have everything you need or do you need to add another USB board to program the chip?

Thanks.

[Synthex]

I want to make the single-layer all-in-one PCB by etching it at home. Is the latest single layer pcb v2.3? Where is the inventory list for it? Does it have everything you need or do you need to add another USB board to program the chip?

Thanks.

All is here : http://www.megadrum.info/forums/viewtopic.php?f=3&t=96&start=0#p925
You need to make cables to program the chips.

[elrules]

I have some doubt about this board.

Do I need to change some resistor value? I know that all over this times modifications have been applied for this board, as some components or values seemed to be better (I think)
Could you tell me if all those resistors and capacitors work well or do you recommend me to change any value to make it work better?

And what the hell is that component located up-right close to the atmega? one with 3 leads and a screw over it. What is that? It does not appear in the list