MegaDrum only works the kick pad. desepetated please help

[juanla]

Hi,
i'm now desepetated beacuse my MegaDrum (Atmega644 32 imputs) built by Dimitri and suddenly stop to work properly.
I have 8 pads, ando only work 1, the kick pad.
i found this very extrange.

i hope any one can give me a hand over here.

Regards
José Luis

[airflamesred]

More detail of the problem, please.

[juanla]

More detail of the problem, please.

Sorry for be not too specific but i dont know much more.
The thing is that i use the megadrum and i upgreated to the new firmware. Then i play some moments and Everything was ok, until i power off the MD. The next moment whrn i turn it on, i hit the pads and didnt respond. Even the cymbals pads didnt work and this cymbals are the ones that came whit the rock band kit. The wired thing is that only the bass drum pad work, and the MD start the red led, and the MDM recognize this pad.
Please tell me if you need more info.

Thanks for your quick reply.

[dmitri]

Start with default settings.

[juanla]

Start with default settings.

hi Dimitri
i reset all the settings by default (acording to http://www.megadrum.info/content); and the megadrum display now show a wired activity in sereval pads, but i'm not hitiing any pad.
I attache one picture that shows this wired activity

i have to say that the red light led is on all the time.




thanks

[dmitri]

What is MaxInputs set to?

[juanla]

What is MaxInputs set to?

56. My megadrum is te 32 versión.
I put the MaxImput at 32 and had the same problem, then I put in a lowe imput number (30) and its ok, but i have a lot of losse hits.
I hit te pad for ex. 10 times and only hear 5 hits.

[dmitri]

It appears that you're NOT using default config. Make sure MaxInputs is set to 32 and make sure AutoLoadConf is set to No.