japi wrote:Thanks.
Yes, I see thin traces from the 4851's (pins 8 and 16) that carry vcc and gnd are veeeery close. I wonder if a faulty component could make this behaviour too, it is posible? In that case, should I check one by one or you suggest starting for a particular component?
I'll investigate and keep you posted.
japi wrote:I'm making synthex's 2.5 right now, so everything is in one board.
http://www.japiwebcam.com.ar/japi/megad ... /index.php
If I take a hi res image, would you be so kind to take a look at it and tell me if you see something suspicious ?
japi wrote:My resistance between vcc and gnd is about 5 ohm, sometimes it will fluctuate a little in readings like 10-20 ohms but it settles at 5 ohms
Thoughts?
Users browsing this forum: No registered users and 66 guests