PCB Inputs Jacks v1.8 for All In One PCB v2.8

[ole_hansen]

please let us have the Gerber data/files

[trapkatman]

Does any one know where to purchase the nys_215 1/4" jacks on the net. I found some switchcraft, but they have locating pins molded on there cases and won't set in the board.

[trapkatman]

I found them. They are a Neutrik part. Here is a merchant in the U.S. :http://www.mouser.com/search/refine.aspx?Msid=56810000&Mkw=nys+215

[madex]

Is it 2 PCBs or 2side PCB ?

Can I use it if i soldering my megadrum at 2 PCBs - analog and digitall?

[dmitri]

Is it 2 PCBs or 2side PCB ?

Can I use it if i soldering my megadrum at 2 PCBs - analog and digitall?

No, you cannot. This inputs jacks PCB is meant for the Synthex's all-in-one PCB.

[MaberY]

I have finished my Synthex 1.8 boards. It was quite a few years agoo I made PCB's at home.
It was big fun again....

I printed the PCB layout on old Tektronix inkjet transparency clear film overhead sheet on my Canon MP970 photoprinter. Nice stuff that film. I used my old DIYS UV lightbox (Double Sided )


This is the result



And etched using a mixture of 500 cc HCL(10%) and 120cc H2O2 (3%) for about 3 minutes.



The Jack PCB plug is a Neutric NYS216. I ordered 25 pieces at http://www.dickbest.nl



And sandwitched.



The 2.8 board is also ready and now i'm about to the drilling stuff for my box and finished designing some frontplates.

[daddy4life85]

Awesome! Looks like those TRS sockets are almost identical to the ones I got. Mine just have a chrome nut instead of the black one. As soon as the parts arrive I'll build mine and post pictures.

[daddy4life85]

Anyone that did these PCB's and ordered parts from mouser or somewhere else inside the states, what part number did you use for the IDE pcb mount connector? I ordered some but they turned out to be like....half sized small ones. If anyone also knows I need a part number for a crimp on IDE female connector that would go on the ribbon cable? Everything else I got worked out I think.

[Synthex]

Very nice work MaberY !!

[Synthex]

what part number did you use for the IDE pcb mount connector?

You must use .100" Header Connectors IDC, Number of Rows = 2, Pitch = 2.54 mm, Number of Positions Contacts = 40